said by DsXsD :

thank you sir

said by retiredcop96 :

I'll save my rants about Earthlink for another time and place and when I have more data.

said by Bill_MI :

You can take snapshots of your signal conditions. But it's only a snapshot so it's a good idea to get snapshots at good and bad times. If you have to watch just one thing, NOISE MARGIN DOWNSTREAM (or similar) is the key. You want it as high as possible and below 8-10db is often bad.

»EarthLink DSL FAQ »How to Get to the Logs, the Diagnostics Page, and the DSL Statistics Page - UHP
or...
»EarthLink DSL FAQ »HowTo obtain DSL Stats & Diagnostic Info from the ZyXEL P-660R-ELNK Router?

One common technique is to take these stats AT THE NID with no house wiring attached. Easy to do with the connectors there. This will show the difference a whole-house splitter can make.

»EarthLink DSL FAQ »How do I test at my NID? What does it look like?

Hope this helps. You can always post your stats here and get opinions.

said by Doctor Olds :

You reset your modem while at its normal current inside location and then save (copy/paste) those fresh stats from your current setup into a text file.

The important numbers to look at are:

• Downstream Sync Rate (or Bit Rate)
• Downstream Noise Ratio (SNR Signal to Noise Margin)
• Downstream Attenuation
• Downstream Output Power
• Downstream Attain Rate (Attainable Rate)
• Downstream Capacity Occupation

Note: Not all modems supply all the stats listed above. Just post what you have.

+++

Keep us informed on what you find with the DSL Stats from the NID test results as that really should be done as soon as possible. Weather permitting of course