halo989
join:2005-01-15 | reply to halo989
Re: ide cable
im pretty sure there arent any
i have gotten this calbe out before (it was a struggle the last time as well) |
|
whymeintrouble
Premium
join:2001-06-20
Woodridge, IL | reply to halo989
Did U Make Sure There Are No Security Tabs Holding The Cable |
|
halo989
join:2005-01-15 | reply to halo989
ok thanks
im just afraid i might break it or something
when i pull on the cable, part of the hdd moves along w/ it |
|
howie
Premium,MVM
join:2003-04-08
Little Falls, NJ
| reply to whymeintrouble
said by whymeintrouble  :you should try to apply equal pressure through the width of the cable, and yes, some do require a bit of pulling. also, remember to pull straight back, that way you aren't fighting the connection in any way. Good advice. I use my thumb and index finger and grasp the ribbon right against the connector and pull straight out. I've never broken a cable doing it this way. Many of the newer IDE ribbon cables have pull tabs at the connector, which make things a bit easier.
--
"Yeah, next time maybe do a little research." - Geico Caveman |
|
whymeintrouble
Premium
join:2001-06-20
Woodridge, IL | reply to halo989
you should try to apply equal pressure through the width of the cable, and yes, some do require a bit of pulling. also, remember to pull straight back, that way you aren't fighting the connection in any way. |
|
halo989
join:2005-01-15 | is there a "proper" way to remove an ide cable?
I try pulling at the ends and kind of rocking it, but its stuck in there pretty good. |
|
