bcbuie
join:2005-07-20
| reply to Airplane777
Re: Tranzeo APs & CPEs signal quality indication
Yes, the Tranzeo's have a web interface to let you read the signal strength. Just plug into the LAN port of the PoE box, and enter the IP address of the Tranzeo. Can't remember the default off the top of my head, but the instructions come with the Tranzeo units.
Ben |
|
Semaphore
Premium
join:2003-11-18
Arnprior On.
| Or you can use the "Trazeo Locator" tool to find it too.
Airplane : Note that there is a bug on the older Tranzeo software that if you enable Infrastructure mode AND Router AND QOS the CPE will be almost completely unreachable. The only way to fix it is by repeatedly power cycling the CPE until you can browse (one screen/click at a time) to the Configuration screen and turn off QOS. This can take you an hour to do since the CPE will only respond to a couple of packets befor going unreachable again  I was reminded of that on Friday night while working on a CPE with old Firmware. It doesn't seem to be a problem on the newer (85r, 86r) stuff.... which that CPE is now upgraded to 
--
www.gozoom.ca |
|
wispman
join:2004-12-21
USA | I don't know of any CPEs that do not have a signal quality indicator viewable by logging in. |
|
