Re: Broadcom WLAN Utility & Driver 3.100.56.0 9X/2

Forums » Equipment Support » Hardware By Brand » Linksys » Broadcom WLAN Utility & Driver 3.100.56.0 9X/2K/XP


Share Topic:	RSS topic:	toggle: flat / full normal / watch	Posting:	Post a:	Post a:

Links: ·Forum Rules ·Forum FAQ ·FTP Modes & Ports ·Linksys Home

[Firmware] WRV54G - NAT-T »
« [Firmware] HyperWRT | Linksys | others?

soganta Premium join:2003-10-15	Re: Broadcom WLAN Utility & Driver 3.100.56.0 9X/2 Yes I was under the same impression, it does recognize my WMP54G as a "Broadcom 802.11g/b" and it installs the drivers but when my PC reboots I get this ! saying "The device cannot start". Also the setup for the utility extracts fine but when it starts to install I get a warning that the setup was aborted.
	permalink · 2005-04-10 10:46:52 ·

Maxxi

@rr.com

Re: Broadcom WLAN Utility & Driver 3.100.56.0 9X/2

Weird - have you tried installing the older (3.100.46.0) build? Regardless, if you can't get these to properly install (and enable your device upon reboot) the Utility WILL NOT INSTALL and will always give you that or another error. Only once the drivers are in place and working/properly loaded, will the Broadcom Utility install correctly. Good luck.

permalink · 2005-04-10 18:01:41 ·

your comment..

Forums » Equipment Support » Hardware By Brand » Linksys	[Firmware] WRV54G - NAT-T » « [Firmware] HyperWRT \| Linksys \| others?


Thursday, 26-Nov 16:17:02	Terms of Use \| Privacy Policy \| Hosting by www.nac.net - DSL,Hosting & Co-lo \| feedback \| contact over 10 years online! © 1999-2009 dslreports.com. page compression OFF