| reply to lordpuffer
Re: [CenturyTel] Q1000 setup questions I am using my own router for wireless and some Ethernet connections and have another switch with more Ethernet connections and a wired AP extending my wireless signal. Right now I turned off nat and DHCP on my router and let the modem do NAT and DHCP and everything seems to be working fine except I can't see my nas. I was wondering if my latency would be better if I set the modem up for transparent mode and let the router handle dhcp. My ping from the router page are is 27ms and from my wireless in the same room is around 70ms. Is the ping test from the modem setup page accurate? Is there something I can look into to get better latency over my setup?
Here are my current WAN Readings. How do these numbers look?
Thanks in advance.
DSL Link Status
Broadband Mode Setting: MULTIMODE
Broadband Mode Detected: VDSL2 - 12A
DSL Link Uptime: 0 Days, 7H:29M:22S
Retrains: 0
Retrains in Last 24 Hours: 0
Loss of Power Link Failures: 0
Loss of Signal Link Failure: 0
Loss of Margin Link Failure: 0
Link Train Errors: 0
Unavailable Seconds: 0
Estimated Loop Length: N/A
Un-Canceled Echo: N/A
Transport Status
VPI: N/A
VCI: N/A
ATM QoS class: N/A
PTM VLAN QoS: 0
MTU Size: 1500
VLAN: PTM 201
Packets Sent: 0
Packets Received: 0
Error Packets Sent: 0
Error Packets Received: 0
30 Minute Discarded Packets Upstream: 0
30 Minute Discarded Packets Downstream: 0
Channel Status
Channel Type: Interleaved
Near End CRC Errors: 0
Far End CRC: 0
30 Minute Near End CRC: 0
30 Minute Far End CRC: 0
Near End RS FEC: 0
Far End RS FEC: 0
30 Minute Near End FEC: 0
30 Minutes Far End FEC: 0
Levels Downstream Upstream
SNR: 26 dB 30 dB
Attenuation: 8 dB 2 dB
Power: 14.1 dBm 11.8 dBm
Modem Memory
Memory
Status
Total Memory:
58MB RAM
Memory Used:
75%
Memory Status:
OK
Recommended Action:
NONE
Modem Sessions
Session
Status
Maximum Number of Sessions:
8192
LAN TCP Sessions:
11
LAN UDP Sessions:
9
Modem Sessions:
0
Total Open Sessions:
20
Session Status:
OK
Recommended Action:
NONE |
