| reply to bgoodbody
Re: and those that applyd and where denied never know said by bgoodbody:Today I got a UPG# for the router shipped, should be here Friday
same here.
--
"It's always funny until someone gets hurt......and then it's absolutely friggin' hysterical!" |
|
| Got it Friday. Installed & Configuered it,
After a while, got eMail from SamKnows confirming install (Its automatic).
You can get password for monitoring before the email by clicking on lost password and they will email a temp one. There will be no data yet, but showed up a couple hours after installed.
New firmware will be available through NetGear, but is available by emailing the community.
Firmware Version V1.2.2.40_34.0.30SK
GUI Language Version V1.2.2.40_2.1.9.1
Noticed that the router can be kept after test.
--
- Bill |
|
| yeap, installed mine, pretty nice to get gig e speeds now on my lan between the gig e switches 
any one else ticked off that going through the install had to be done ?
My linux box would not open the index.html so I had to run it through wine.
--
"It's always funny until someone gets hurt......and then it's absolutely friggin' hysterical!" |
|
| I did not use the Install Disk. Just the web interface at: 192.168.1.1. The configuration is just like any other router. The new Firmware offers an IPV6 page if you want it.
--
- Bill |
|
|
|
| I had to, it would not connect to the internet without it !
Also does the new firmware have to be downloaded by the installer or can we force it up there ?
--
"It's always funny until someone gets hurt......and then it's absolutely friggin' hysterical!" |
|
| It is loaded using the router interface.
--
- Bill |
|
