Broadband Tech > General Questions > How do you make a graph like this?

How do you make a graph like this?

Most spreadsheet software like Excel will transform data into custom graphs.

Is that what you are asking?

Fastest way if you don't know Excel is to get graph paper and colored pens... :-D

reply to Subaru
Is it hard to do a graph like this? I don't know excel that well never had to really use it

reply to Subaru
That was done in excell. You just have your x values and in this case 2 y values. insert scatter plot and tell it where to look for data. Easy, and if you know what you rae doing it should take all of 10 seconds to make the graphs if you have the data typed in.
--
tight lines and screaming reels

reply to Subaru
Looks like a graph taht I did in Quality Control, x bar charts and such.
--
Do or do not, there is no try! - Yoda

reply to Subaru

reply to Subaru

TWG chart.xlsx.zip 8,225 bytes

What are columns A and B?

and what are you trying to show?

Left side Mv Peak-to-peak

and horizontal would be the number of tonewheels (you know this project)

Long story is it has to be calibrated and I wanted to graph out the before and after.

reply to Subaru
A question when doing the X and Y data Can one not have more data then the other?

My y Axis is numbered from 44 to 91 but my X axis is 0 to 30

pretty much like the sample graph I posted above However when I go to insert and click on scatter graph I just get a blank window and no data shown.

I think I need to pick my data first

reply to Subaru
Right a tone wheel and it's output, side by side for each wheel

reply to Subaru
How's this

[att=1]

says I can't open it?