[Equipment] First time 900 Canopy configuration

Forums » Industry Forums » Wireless Service Providers » [Equipment] First time 900 Canopy configuration


Uniqs: 254	Share Topic:	RSS topic:	toggle: flat / full normal / watch	Posting:	Post a:	Post a:

Links: ·WISP Forum FAQ ·WISP Directory ·WISP Forum Frappr Map ·Radio Mobile

Outdoor Double Shielded Cat5e »
« Changing Polarization

compctech join:2009-06-26 Winchester, VA	[Equipment] First time 900 Canopy configuration I am working on setting up a Motorola Canopy 900 network. I can have the SM unit register if I am within a half of a mile from the AP unit. If I go over it I am not able to connect. Dose anyone have any ideas. I have the Max Range set to 30 Miles. What should I check next?
	permalink · 2009-07-02 13:52:05 ·

Semaphore
Premium
join:2003-11-18
Arnprior On.

Re: [Equipment] First time 900 Canopy configuration

Sounds to me like your Antenna polarity is mismatched - did you verify that? The Integrated AP's and CPE's (the ones that don't need an External Antenna) are HPOL. If you are using an OMNI on the AP and you went cheap then it's probably VPOL. That would result in the symptom/problem you are seeing.
Did you run the spectrum analyzer to see what the spectrum is like ? You could be over the noise floor.
Are you sure you don't have a Fresnel refraction causing the CPE not to be able to associate ?
Moto's good but it doesn't do Dirt which a lot of people seem to think is possible with NLOS.

S

permalink · 2009-07-02 16:14:13 · Print ·

your comment..

Forums » Industry Forums » Wireless Service Providers	Outdoor Double Shielded Cat5e » « Changing Polarization


Saturday, 28-Nov 13:29:58	Terms of Use \| Privacy Policy \| Hosting by www.nac.net - DSL,Hosting & Co-lo \| feedback \| contact over 10 years online! © 1999-2009 dslreports.com. republican-creole page compression OFF