Search:  

 
 
   All ForumsHot TopicsGallery






how-to block ads


 
Forums » Equipment Support » Hardware By Brand » Linksys » [Wired] BEFSR41 - WAN Connection Reset - Rx PPP TERM_REQ
Search Topic:
Share Topic:
RSS topic:
toggle:
flat / full
normal / watch
Posting:
Post a:
Post a:
Tomato Question »
« [Tomato] LAN bandwidth monitoring with Tomato  
AuthorAll Replies


Megistal

@aei.ca

reply to Mountaineer1
Re: [Wired] BEFSR41 - WAN Connection Reset - Rx PPP TERM_REQ

Hummm how can I say that

I've plug my modem directly in my PC.
Internet was available and tried the admin password (without success, I'm the only one who can change it so I'm wondering why it has changed, the modem was new when I bought it)

Then I've switched back with the router, Internet still accessible.

After these two switch (router -> modem -> router) if I tried to plug my modem back in the pc, I'm unable to gain access on the internet even if I reboot the modem and disable / enable the network card.

However using the router, internet is accessible right away.

Weird...


Megistal

@aei.ca
I've found that the password might be different. Maybe they changed it somehow. I'll try the new one when I'll be able to acces my modem directly via the pc


Mountaineer1
Big WVU Fan
Premium,MVM
join:2002-01-12
Universe
·AT&T Yahoo


edit:
September 18th, @05:26PM

Does the router automatically get an IP address from the modem,via DHCP or do you use PPPoE as the WAN type?
--
Got a Clark,Crown,Drexel forklift and need technical advice? Ask me about it.


Megistal

@aei.ca
I'm using PPPoE


Mountaineer1
Big WVU Fan
Premium,MVM
join:2002-01-12
Universe
·AT&T Yahoo


edit:
September 18th, @06:21PM

Click for full size
Then your ISP must have the modem locked into bridge mode,since the router is handling the PPPoE authentication. Is the router's WAN PPPoE set to "Keep Alive: Redial Period 30 Sec."? Is your MTU set to 1492?
--
Got a Clark,Crown,Drexel forklift and need technical advice? Ask me about it.


Megistal

@aei.ca

Yes it is, but set to 60 seconds

MTU: 1424
Local DHCP Server: On
DDNS: Disable
MAC Clone: Disable
NAT: Enable
Dynamic Routing: Disable
Block Anonymous Internet Requests: On
Filter Multicast: Off
Filter Internet NAT Redirection: Off
Filter IDENT(port 113): On


Megistal

@aei.ca

reply to Mountaineer1
I already had the MTU issue but it is solved from a long time ago (easier to detect imo).

I could use an higher value but this is the recommended value from the ISP so for troubleshooting something else I'll leave it as-is for now (and I didn't had any issue lowering it)


Mountaineer1
Big WVU Fan
Premium,MVM
join:2002-01-12
Universe
Have you had this modem for quite a while,or is this a new unit?


Megistal

@aei.ca
I bought both (modem & router) on June last year (2007)


Mountaineer1
Big WVU Fan
Premium,MVM
join:2002-01-12
Universe
And this disconnection problem just started recently,or is this an ongoing issue? Are all analog devices(Phones,Fax,Cable/SAT Box)filtered?
--
Got a Clark,Crown,Drexel forklift and need technical advice? Ask me about it.


Megistal

@aei.ca

An ongoing issue that I was tired of but never had much time to spare on it. When it's happening, I disconnect and reconnect the router (5 sec delay on average) and the connection is brought back immediately (well the time Windows need to reconnect on the router, the little animation of the network connection in the systray)

Yes everything is analog.
I only have a single phone here which is filtered.

Only internet & the phone on the line, nothing more.


Mountaineer1
Big WVU Fan
Premium,MVM
join:2002-01-12
Universe
So you're losing the connection between the router,and the PC card?


Megistal

@aei.ca

I would say from the router to the modem because when it's occurring I can still access the other PC normally.

What I've noticed when a disconnection occurs:
- ISP's logs does not show me as disconnected.
- Modem WAN light is not blinking (for SLAM connection)
- Modem ALM (alarm) light is not lit
- WAN is not accessible
- Both computers connected via LAN using the router are accessible and can see each other and exchange files without issues
- Rx PPP TERM_REQ code appear in the Router Log
- WAN Router Status is "Connecting" (not connected)
- Windows on all computers does not "lose" the connection with the router

I suppose the router has something not well configured / defective / issue communicating with the modem / a virus but I would be very surprised by the latter


Mountaineer1
Big WVU Fan
Premium,MVM
join:2002-01-12
Universe

edit:
September 20th, @12:30PM

It sounds like a modem sync issue,too me. Do you have another modem,or can you borrow a modem to test with?
--
Got a Clark,Crown,Drexel forklift and need technical advice? Ask me about it.
-
Forums » Equipment Support » Hardware By Brand » LinksysTomato Question »
« [Tomato] LAN bandwidth monitoring with Tomato  


Wednesday, 07-Jan 19:42:18 Terms of Use | Privacy Policy | Hosting by www.nac.net - DSL,Hosting & Co-lo | feedback | contact
over 9 years online! © 1999-2009 dslreports.com.
page compression OFF
Most commented news this week
· [160] New Comcast Throttling System 100% Online
· [110] After 10 Years Of Service, Charter Declares Home 'Unserviceable'
· [105] iTunes Dumps The DRM
· [70] AT&T, Verizon Stocks Tumble
· [54] Feds Start Wait List For DTV Converter Coupons
· [52] Cable To Grab 75% Of New Subs In 2009
· [38] Netflix Via LG HDTVs
· [37] DOCSIS 3.0 Gets Faster
· [36] New Zealand's 'One Strike' Piracy Law
· [35] ISPs Won't Admit Participation In New RIAA Plan
Most people now reading
· [Rant] cops and illegal searches [Rants, Raves, & Praise]
· Verry unhappy... [TekSavvy]
· MLPPP: Fail - ERX06 [TekSavvy]
· Nobody Told Me! [TekSavvy]
· Can't order UVerse and then cancel TV later [AT&T U-verse]
· What's the issue with shipping to a PO Box? [General Questions]
· anyone else getting high pings and slow speeds now? [TekSavvy]
· Constant Network Maintenance interruptions [TekSavvy]
· How to download windows 7 beta [Microsoft help]
· [ Professions] Northrend Herbalism and Mining Tracks [World of Warcraft]