mysidia
join:2002-05-16
Hammond, LA | reply to kracksmith
Re: Inserted a new WIC, need command
Except in high-end models, hot swap of WAN Interface Cards is generally not supported.
You haven't indicated what model gear and what type of WIC. But you most likely need to power cycle. |
|
kracksmith
join:2004-07-14
Fullerton, CA | it's only a 2811 and WIC is a dual T1 card.
show controllers doesn't bring out the interfaces in the config. |
|
Da Geek Kid
join:2003-10-11
Mclean, VA | well, 1st of all you run the sh contr to see if the device is recognized...
next you do controller command in config t... |
|
