kracksmith
join:2004-07-14
Fullerton, CA | Inserted a new WIC, need command
I just inserted a new dual port WIC for a new P2P. Current config doesn't auto recognize. what command do i type in to be able to see these new intefaces? |
|
Da Geek Kid
join:2003-10-11
Mclean, VA | show controllers |
|
mysidia
join:2002-05-16
Hammond, LA | reply to kracksmith
Except in high-end models, hot swap of WAN Interface Cards is generally not supported.
You haven't indicated what model gear and what type of WIC. But you most likely need to power cycle. |
|
kracksmith
join:2004-07-14
Fullerton, CA | it's only a 2811 and WIC is a dual T1 card.
show controllers doesn't bring out the interfaces in the config. |
|
devicemanage
Premium
join:2002-03-16
Chalfont, PA | reply to kracksmith
Does your ios support this WIC?
--
»www.devicemanager.net |
|
Da Geek Kid
join:2003-10-11
Mclean, VA | reply to kracksmith
well, 1st of all you run the sh contr to see if the device is recognized...
next you do controller command in config t... |
|
zno
join:2002-01-08
Atlanta, GA
| reply to kracksmith
assuming you have the WIC in slot 0...
--
got anti-virus and firewall? |
|
