I dont understand this... in Wireless Networking http://www.dslreports.com/forum/r20557049 en Fri, 05 Dec 2008 03:14:30 EDT Fri, 05 Dec 2008 03:14:30 EDT Re: I dont understand this... http://www.dslreports.com/forum/remark,20737495 stevech0 : or 2.4GHz cordless phone. Or 2.4GHz analog on RF video camera (CCTV).

Can be badly transmitted signal (bad EVM as noted earlier, due to crummy amplifier or overdriven amplifier), or bad received signal due to interference or high noise floor due to use of cheap amplifier. In general, WiFi bi-directional amplifiers are a net-loss compared to better high gain omni or other antennas, so long as your radiated power is regulatory-compliant.]]> http://www.dslreports.com/forum/remark,20737495 Thu, 03 Jul 2008 14:56:55 EDT Re: I dont understand this... http://www.dslreports.com/forum/remark,20736374 LLigetfa : I think the OP is into running amps and very high EIRP. Thats what you get (EVM) when you run cheap amps and OFDM.]]> http://www.dslreports.com/forum/remark,20736374 Thu, 03 Jul 2008 11:10:14 EDT Re: I dont understand this... http://www.dslreports.com/forum/remark,20736339 cacroll :
said by ackovski See Profile :

It seems something is fried. :(


Maybe, it's time for Frys.
»www.frys.com/
--
Cheers,
Chuck
MS-MVP 2005-2008 [Windows - Desktop Experience]
Nitecruzr Dot Net]]> http://www.dslreports.com/forum/remark,20736339 Thu, 03 Jul 2008 11:02:48 EDT Re: I dont understand this... http://www.dslreports.com/forum/remark,20736228 ackovski : It seems something is fried. :(]]> http://www.dslreports.com/forum/remark,20736228 Thu, 03 Jul 2008 10:36:04 EDT Re: I dont understand this... http://www.dslreports.com/forum/remark,20557279 cacroll :
said by ackovski See Profile :

It was working fine and nothing is changed in preferences.


You may get excellent signal strength from any AP, yet the noise level (analogue or digital) may produce unacceptable link quality. Your neighbour may put his own AP on the same channel. Or maybe somebody fired up his microwave oven, as you were doing your test. Or a dozen other possibilities, which can override raw signal strength, and not require you to change anything in preferences.
»networking.nitecruzr.net/2005/10···net.html

Maybe a site survey would be a good idea.
»networking.nitecruzr.net/2006/06···ent.html
--
Cheers,
Chuck
MS-MVP 2005-2007 [Windows - Networking]
PChuck's Network]]> http://www.dslreports.com/forum/remark,20557279 Thu, 29 May 2008 11:22:52 EDT I dont understand this... http://www.dslreports.com/forum/remark,20557049 ackovski : It was working fine and nothing is changed in preferences.
It may be damaged by higher voltage.
Any idea how to fix this?
Click for full size
]]> http://www.dslreports.com/forum/remark,20557049 Thu, 29 May 2008 10:39:33 EDT