The modem itself, with the shipped firmware, supports 3 modes; PPPoE on board, Bridge mode, Bridge mode with IP Address pass Issuance. To put the modem in Bridge modem do the following:
1. In your web browser browse to »192.168.0.1 This address will be located on a yellow sticker on the bottom of your modem.
2. The first screen will ask you for your Modem Access Code. This also will be located on the same yellow sticker.
3. Select Advanced from the blue buttons on the left.
4. Click the PPP locations button.
5. The modem may ask your for the Modem Access Code again. If so type it in again and click continue.
6. Select the radio button labeled, "Bridged Mode (PPPoE is not used)"
7. Click Save Changes.
8. A "PPP Location Warning" page will come up. Click "Change PPP Location."
9. A "Restart Needed" page will come up. Click "Restart"
10. Reboot your computer and router (if applicable.) You will now need some form of PPPoE software on your computer or a router that supports PPPoE. Be warned that even if you are using Enternet 300 or XP/OSX's built in PPPoE SBC tech support will not troubleshoot connectivity issues until you have put your modem back in PPPoE on board mode.
 feedback form
 feedback form
by Maxo  edited by Flippant
last modified: 2008-02-16 14:27:10 |
